WALL-MOUNTED PAPER DISPENSER KIT - 1 dispenser, 1 roller paper, 1 horizontal fixed strip, fixed strip is a cutter, you can tear your paper to save your artwork or office concept.
*STUDIO CREATIVE WALL - Good helper in the conference room
*STORE WALL INSTALLATION LIST - Restaurants day menu board
*PAPER SELECTION - 120G Russian roll Kraft paper, thickness is two A4 paper, the ink will not print through the wall when writing, will not pollute the white wall; the front and back of the paper can be reused.
Now we will introduce below information to you.
1 The Spare Parts of Wall Mounted Roll Paper Cutter Dispenser.
2 The Needed Tools for Wall Mounted Roll Paper Cutter Dispenser.
3 The installation Step to Mount A Wall Mounted Paper Dispenser.
1 The Spare Parts of Wall Mounted Roll Paper Cutter Dispenser.
Wall Mount Paper Cutter include A wall mount bracket, B Iron Paper Roll Holder, C Cutter Bar, D 50 Meter Roll Paper, E Screws, F Anchor.
2 The Needed Tools for Wall Mounted Roll Paper Cutter Dispenser.
Hammer, Drill, Head Screw Drives, Level.
3 The installation Step to Mount A Wall Mounted Paper Dispenser.
Step 1
While holding the dispenser against the wall, use a level to ensure the dispenser is straight. Then use a pencil to mark the dispenser holes on the wall.
Step 2
Using power drill and 1/4“ size drill bit, drill holes in the wall through the pencil marks.
Step 3
For wood wall installation use the 4 wood screws and 4 wall anchors. (NOTE - for wood stud installation the wall anchors may not be needed). Push anchors through the drilled holes and lightly tap with a hammer. Use Phillips head screw driver or power drill to mount wall mount frame to wall.
For drywall installation we recommend using the included toggle bolts.
Step 4
Slide the roll of Kraft paper over the metal dowel and place on wall mount bracket. Note that each end if the metal dowel does unscrew if you need to widen the track to slide into the wall mount bracket.
Step 5
Using 2 Wood Screws/Wall Anchors/Toggle bolts install the cut bar at your desired distance below the wall mount bracket (see above). Make sure the grooved part of the cut bar faces down.